Acura 2013 TL - Manual (Page 557)

The fluid level should be between
the MIN and MAX marks on the side
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected for leaks or
worn brake pads.
You need to remove the left engine
compartment cover to check the
fluid level (see page
).
Check the fluid level in the
reservoirs monthly. There are up to
two reservoirs, depending on the
model. They are:
Brake fluid reservoir (all models)
Clutch fluid reservoir
(manual transmission models
only)
To access the reservoirs, remove the
left engine compartment cover (see
page
).
You will also see a ‘‘LOW BRAKE
FLUID’’ message on the multi-
information display.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
container, as a temporary
replacement.
Brake fluid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage.
Using any non-Honda brake fluid can
cause corrosion and decrease the life
of the system. Have the brake
system flushed and refilled with
Honda Heavy Duty Brake Fluid
DOT 3 as soon as possible.
Independent of the Maintenance
Minder information, replace the
brake fluid every 3 years.
542
542
Brake and Clutch Fluid
Brake Fluid
Ma
int
e
na
nce
553
MAX
MIN
12/07/20 11:41:20 31TK4640_558
2013 TL