Acura 2013 TL - Manual (Page 541)

Your dealer will reset the display
after completing the required
maintenance service. You will see
‘‘OIL LIFE 100%’’ on the display the
next time you turn the ignition
switch to the ON (II) position.
Turn the ignition switch to the
ON (II) position.
If maintenance service is done by
someone other than your dealer,
reset the Maintenance Minder as
follows:
If the engine oil life is not
displayed, press the SEL/RESET
button on the steering wheel
repeatedly.
Press and hold the SEL/RESET
button on the steering wheel for
more than 10 seconds. The
remaining engine oil life reset
mode will be shown on the multi-
information display.
Select ‘‘RESET’’ by pressing the
INFO (
) button, then press the
SEL/RESET button to reset the
engine oil life display. The
maintenance item code(s) will
disappear, and the engine oil life
will reset to ‘‘100.’’ If you want to
cancel the oil life reset mode,
select ‘‘CANCEL.’’
3.
1.
2.
4.
Maintenance Minder
Resetting the Engine Oil Lif e
Display
Ma
int
e
na
nce
537
TM
12/07/20 11:39:21 31TK4640_542
2013 TL
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. ON Mode is the equivalent of
ON (II). For more information, see
pages
and .
:
184 187
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. ON Mode is the equivalent of
ON (II). For more information, see
pages
and .
:
184 187