QTECH QSW-2800 Инструкция по настройке - Manual (Page 158)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
144
9. Configure the FLUSH mode once topology changes
18.3 MSTP Example
The following is a typical MSTP application example:
Typical MSTP Application Scenario
Command Explanation
Global Mode
spanning-tree tcflush {enable| disable| protect}
no spanning-tree tcflush
Enable: the spanning-tree flush once the
topology changes.
Disable: the spanning tree don’t flush
when the topology changes.
Protect: the spanning-tree flush not more
than one time every ten seconds.
The no command restores to default
setting, enable flush once the topology
changes.
Port Mode
spanning-tree tcflush {enable| disable| protect}
no spanning-tree tcflush
Configure the port flush mode.
The no command restores to use the
global configured flush mode.
Switch2 Switch3
Switch4
1
1
2
2
3 5 4
2
3
1
6 7
5
4 6 7
x
x x
x
x
Switch1