QTECH QSW-2800 Инструкция по настройке - Manual (Page 307)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
293
no dot1x privateclient
enable
function.
dot1x user free-
resource <prefix>
<mask>
no dot1x user free-
resource
Sets free access network resource for unauthorized dot1x user.
The no command close the resource.
dot1x unicast enable
no dot1x unicast enable
Enable the 802.1x unicast passthrough function of switch; the no
operation of this command will disable this function.
2. Access management unit property configuration
1) Configure port authentication status
Command Explanation
Port Mode
dot1x port-control
{auto|force-
authorized|force-
unauthorized }
no dot1x port-control
Sets the 802.1x authentication mode; the no command restores
the default setting.
2) Configure port access management method
Command Explanation
Port Mode
dot1x port-method {macbased | portbased
| userbased {standard | advanced}}
no dot1x port-method
Sets the port access management method;
the no command restores MAC-based access
management.
dot1x max-user macbased <number>
no dot1x max-user macbased
Sets the maximum number of access users for
the specified port; the no command restores
the default setting of allowing 1 user.
dot1x max-user userbased <number>
no dot1x max-user userbased
Set the upper limit of the number of users
allowed accessing the specified port, only
used when the access control mode of the
port is userbased; the no command is used to
reset the limit to 10 by default.
dot1x guest-vlan <vlanID>
no dot1x guest-vlan
Set the guest vlan of the specified port; the no
command is used to delete the guest vlan.
dot1x portbased mode single-mode
no dot1x portbased mode single-mode
Set the single-mode based on portbase
authentication mode; the no command
disables this function.