QTECH QSW-2800 Инструкция по настройке - Manual (Page 268)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
254
no ipv6 mld snooping vlan <vlan-id>
query-robustness
ipv6 mld snooping vlan <vlan-id>
suppression-query-time <value>
no ipv6 mld snooping vlan <vlan-id>
suppression-query-time
Configure the suppression query time. The “no”
form of this command restores to the default
Ipv6 mld snooping vlan <vlan-id>
static-group <X:X::X:X> [source
<X:X::X:X>] interface [ethernet | port-
channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-id>
static-group <X:X::X:X> [source
<X:X::X:X>] interface [ethernet | port-
channel] <IFNAME>
Configure static-group on specified port of the
VLAN. The no form of the command cancels this
configuration.
35.1.3 MLD Snooping Examples
Scenario 1: MLD Snooping Function
Open the switch MLD Snooping Function figure
As shown above, the vlan 100 configured on the switch consists of ports 1, 2, 6, 10, 12. Four
hosts are respectively connected to 2, 6, 10, 12 while the multicast router on port 1. Suppose
we need MLD Snooping on VLAN 100, however by default, the global MLD Snooping as well
as the MLD Snooping on each VLAN are, therefore first we have to enable the global MLD
Snooping at the same time enable the MLD Snooping on VLAN 100, furthermore we need to
set the port 1 of VLAN 100 as a mrouter port.
Configuration procedure is as follows.
Switch#config
Switch(config)#ipv6 mld snooping
Multicast Router
Mrouter Port
MLD Snooping
Switch
Group1 Group1 Group1 Group2