QTECH QSW-2800 Инструкция по настройке - Manual (Page 316)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
302
39.2 The Number Limitation
Function of MAC in Port
Configuration Task Sequence
1. Enable the number limitation function of MAC on ports
2. Configure the violation mode of ports
3. Display and debug the relative information of number limitation of MAC on ports
1. Enable the number limitation function of MAC on ports
Command Explanation
Port configuration mode
switchport mac-address dynamic maximum
<value>
no switchport mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC on the ports.
2. Configure the violation mode of ports
Command Explanation
Port mode
switchport mac-address violation {protect |
shutdown} [recovery <5-3600>]
no switchport mac-address violation
Set the violation mode of the port, the no
command restores the violation mode to
protect.
3. Display and debug the relative information of number limitation of MAC on ports
Command Explanation
Admin mode
show mac-address dynamic count {vlan
<vlan-id> | interface ethernet
<portName> }
Display the number of dynamic MAC in
corresponding ports, the VLAN option is not
supported by switch.
debug switchport mac count
no debug switchport mac count
All kinds of debug information when limiting
the number of MAC on ports.