QTECH QSW-2800 Инструкция по настройке - Manual (Page 351)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
337
PPPoE IA - vendor tag (4 bytes in each row)
Add TLV tag as 0x0105 for PPPoE IA, TAG_LENGTH is length field of vendor tag;
0x00000DE9 is “ADSL Forum” IANA entry of the fixed 4 bytes; 0x01 is type field of Agent
Circuit ID, length is length field and Agent Circuit ID value field; 0x02 is type field of Agent
Remot ID, length is length field and Agent Remote ID value field.
PPPoE IA supplies a default circuit ID value, the default circuit ID (The figure in the following)
includes 5 fields, ANI (Access Node Identifier) can be configured by user, its length is less than
47 bytes. If there is no ANI configured, MAC is accessed by default, occupy 6 bytes and use
space symbol to compart, “eth” occupies 3 bytes and uses space symbol to compart, “Slot ID”
occupies 2 bytes, use “/” to compart and occupy 1 byte, “Port Index” occupies 3 bytes, use “:”
to compart and occupy 1 byte, “Vlan ID” occupies 4 bytes, all fields use ASCII, user can
configure ciucuit ID for each port according to requirement.
ANI
(n byte)
Space
( 1byte)
eth
(3 byte)
Space
(1 byte)
Slot ID
(2 byte)
/
(1byte)
Port Index
(3 byte)
:
(1 byte)
Vlan ID
(4 byte)
Fig 11-3 Agent Circuit ID value
MAC of the access switch is the default remote ID value of PPPoE IA. remote ID value can be
configured by user flexibly, the length is less than 63 bytes.
47.1.2.4 Trust Port of PPPoE Intermediate Agent
Discovery stage sends five kinds of packets, PADI and PADR packets sent by client to server,
PADO and PADS packets sent by server to client, PADT packet can be sent by server or client.
In PPPoE IA, for security and reduce traffic, set a port connected server as trust port, set ports
connected client as untrust port, trust port can receive all packets, untrust port can receive only
PADI, PADR and PADT packets which are sent to server. To ensure client operation is correct,
it must set the port connected server as trust port, each access device has a trust port at least.
PPPoE IA vendor tag can not exist in PPPoE packets sent by server to client, so we can strip
and forward these vendor tags if they exist in PPPoE packets. Strip function must be
configured on trust port, enabling strip function is not take effect on untrust port.
47.2 PPPoE Intermediate Agent
Configuration Task List
1. Enable global PPPoE Intermediate Agent
2. Enable port PPPoE Intermediate Agent
Command Explanation
Global Mode
pppoe intermediate-agent Enabel global PPPoE Intermediate Agent