QTECH QSW-2800 Инструкция по настройке - Manual (Page 63)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
49
Chapter 5 Port Isolation Function Configuration
5.1 Introduction to Port Isolation
Function
Port isolation is an independent port-based function working in an inter-port way, which
isolates flows of different ports from each other. With the help of port isolation, users can
isolate ports within a VLAN to save VLAN resources and enhance network security. After this
function is configured, the ports in a port isolation group will be isolated from each other, while
ports belonging to different isolation groups or no such group can forward data to one another
normally. No more than 16 port isolation groups can a switch have.
5.2 Task Sequence of Port Isolation
1. Create an isolate port group
2. Add Ethernet ports into the group
3. Display the configuration of port isolation
1. Create an isolate port group
Command Explanation
Global Mode
isolate-port group <WORD>
no isolate-port group <WORD>
Set a port isolation group; the no operation of this
command will delete the port isolation group.
2. Add Ethernet ports into the group
Command Explanation
Global Mode
isolate-port group <WORD>
switchport interface [ethernet]
<IFNAME>
no isolate-port group <WORD>
switchport interface [ethernet]
<IFNAME>
Add one port or a group of ports into a port isolation
group to isolate, which will become isolated from
the other ports in the group; the no operation of this
command will remove one port or a group of ports
out of a port isolation group.