QTECH QSW-2800 Инструкция по настройке - Manual (Page 262)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
248
ip igmp snooping vlan <vlan-id> mrouter-
port learnpim
no ip igmp snooping vlan <vlan-id>
mrouter-port learnpim
Enable the function that the specified VLAN
learns mrouter-port (according to pim packets),
the no command will disable the function.
ip igmp snooping vlan <vlan-id> mrpt
<value >
no ip igmp snooping vlan <vlan-id> mrpt
Configure this survive time of mrouter port.
The “no ip igmp snooping vlan <vlan-id>
mrpt
” command restores the default value.
ip igmp snooping vlan <vlan-id> query-
interval <value>
no ip igmp snooping vlan <vlan-id> query-
interval
Configure this query interval. The “no ip igmp
snooping vlan <vlan-id> query-interval ”
command restores the default value.
ip igmp snooping vlan <vlan-id>
immediately-leave
no ip igmp snooping vlan <vlan-id>
immediately-leave
Enable the IGMP fast leave function for the
specified VLAN: the “no ip igmp snooping
vlan <vlan-id> immediate-leave ” command
disables the IGMP fast leave function.
ip igmp snooping vlan <vlan-id> query-
mrsp <value>
no ip igmp snooping vlan <vlan-id> query-
mrsp
Configure the maximum query response
period. The “no ip igmp snooping vlan
<vlan-id> query-mrsp
” command restores to
the default value.
ip igmp snooping vlan <vlan-id> query-
robustness <value>
no ip igmp snooping vlan <vlan-id> query-
robustness
Configure the query robustness. The “no ip
igmp snooping vlan <vlan-id> query-
robustness
” command restores to the default
value.
ip igmp snooping vlan <vlan-id>
suppression-query-time <value>
no ip igmp snooping vlan <vlan-id>
suppression-query-time
Configure the suppression query time. The “no
ip igmp snooping vlan <vlan-id>
suppression-query-time ” command restores
to the default value.
ip igmp snooping vlan <vlan-id> static-
group <A.B.C.D> [source <A.B.C.D>]
interface [ethernet | port-channel]
<IFNAME>
no ip igmp snooping vlan <vlan-id> static-
group <A.B.C.D> [source <A.B.C.D>]
interface [ethernet | port-channel]
<IFNAME>
Configure static-group on specified port of the
VLAN. The no form of the command cancels
this configuration.