QTECH QSW-2800 Инструкция по настройке - Manual (Page 411)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
397
Display executed-commands state
59.7.3 System Log Configuration Example
Example 1: When managing VLAN the IPv4 address of the switch is 100.100.100.1, and the
IPv4 address of the remote log server is 100.100.100.5. It is required to send the log
information with a severity equal to or higher than warnings to this log server and save in the
log record equipment local1.
Configuration procedure:
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 100.100.100.1 255.255.255.0
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 100.100.100.5 facility local1 level warnings
Example 2: When managing VLAN the IPv6 address of the switch is 3ffe:506::1, and the IPv4
address of the remote log server is 3ffe:506::4. It is required to send the log information with a
severity equal to or higher than critical to this log server and save the log in the record
equipment local7.
Configuration procedure
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 address 3ffe:506::1/64
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 3ffe:506::4 facility local7 level critical
Command Description
Admin mode
show logging executed-commands state
Show the state of logging executed-
commands