QTECH QSW-2800 Инструкция по настройке - Manual (Page 257)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
243
Destination Control Configuration
Multicast Strategy Configuration
Source Control Configuration
Source Control Configuration has three parts, of which the first is to enable source control. The
command of source control is as follows:
Command Explanation
Global Configuration Mode
[no] ip multicast source-
control (Required)
Enable source control globally, the “no ip multicast source-
control ” command disables source control globally. It is
noticeable that, after enabling source control globally, all
multicast packets are discarded by default. All source control
configuration can not be processed until that it is enabled
globally, while source control can not be disabled until all
configured rules are disabled.
The next is to configure the rule of source control. It is configured in the same manner as for
ACL, and uses ACL number of 5000-5099, every rule number can be used to configure 10
rules. It is noticeable that these rules are ordered, the front one is the one which is configured
the earliest. Once the configured rules are matched, the following rules won’t take effect, so
rules of globally allow must be put at the end. The commands are as follows:
Command Explanation
Global Configuration Mode
[no] access-list <5000-5099>
{deny|permit} ip {{<source> <source-
wildcard>}|{host-source <source-host-
ip>}|any-source} {{<destination>
<destination-wildcard>}|{host-
destination <destination-host-ip>}|any-
destination}
The rule used to configure source control. This
rule does not take effect until it is applied to
specified port. Using the NO form of it can
delete specified rule.
The last is to configure the configured rule to specified port.
Note: If the rules being configured will occupy the table entries of hardware, configuring too
many rules will result in configuration failure caused by bottom table entries being full, so we
suggest user to use the simplest rules if possible. The configuration rules are as follows:
Command Explanation
Port Configuration Mode
[no] ip multicast source-control access-
group <5000-5099>
Used to configure the rules source control uses
to port, the NO form cancels the configuration.
Destination Control Configuration