QTECH QSW-2800 Инструкция по настройке - Manual (Page 236)

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
222
ipv6 dhcp use class
no ipv6 dhcp use class
This command enables DHCPv6 server to
support the using of DHCPv6 class during
address assignment, the no form of this
command disables it without removing the
relative DHCPv6 class information that has
been configured.
ipv6 dhcp class <class-name>
no ipv6 dhcp class <class-name>
This command defines a DHCPv6 class and
enters DHCPv6 class mode, the no form of
this command removes this DHCPv6 class.
Interface configuration mode
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
This command enables the DHCPv6 server to
support selections when multiple option 37 or
option 38 options exist and the option 37 and
option 38 of relay-forw in the innermost layer
are selected. The no operation of it restores
the default configuration, i.e. selecting option
37 and option 38 of the original packets.
IPv6 DHCP Class configuration mode
{remote-id [*] <remote-id> [*] | subscriber-
id [*] <subscriber-id> [*]}
no {remote-id [*] <remote-id> [*] |
subscriber-id [*] <subscriber-id> [*]}
This command configures option 37 and option
38 that match the class in ipv6 dhcp class
configuration mode.
DHCPv6 address pool configuration mode
class <class-name>
no class <class-name>
This command associates class to address
pool in DHCPv6 address pool configuration
mode and enters class configuration mode in
address pool. Use no command to remove the
link.
address range <start-ip> <end-ip>
no address range <start-ip> <end-ip>
This command is used to set address range
for a DHCPv6 class in DHCPv6 address pool
configuration mode, the no command is used
to remove the addreass range. The prefix/plen
form is not supported.