Elmo Rietschle 2FC4...-1CB - Manual (Page 19)

Installation 5
© Gardner Denver Deutschland GmbH 19 / 74 05.2014 · 610.00260.40.000
The standard adapter plate is an adapter plate whose lower part has not
been refinished. No holes are drilled.
 For the motors supplied, you can order adapter plates from the manufacturer.
5. Adjust them to the adapter plate (1) by drilling appropriate holes (2) in them
for attachment to the motor.
The system start-up engineer is responsible for maintaining the protection
class for the gasket of the adapter plate on the motor.
 For questions, please contact your sales representative.
6. Insert the gasket (3).
7. Lead the motor connection cable through the adapter plate while bypassing
the terminal and screw the adapter plate onto the motor using four fastening
screws and four spring elements (4) (torque: 2.0 Nm [1.48 ft lbs]).
when mounting the adapter plates, ensure that all four screws, including the
spring elements are tightened by applying the correct torque! All contact
areas must be dirt/ paint-free, as correct protective earth connection can-
not be ensured otherwise.
8. Connect the motor wires to the required interconnection, see also Figure 5
(Torque: 3.0 Nm [2.21 ft lbs]). We recommend using insulated M5 ring termi-
nals, with a connection cross-section of 4-6 mm
2 [0.16 to 0.24 inch 2 ]
When installing the motor wires make sure that all bolts on the adapter
board are fitted with the enclosed nuts, even if the neutral point is not con-
nected.
Jumper
9. Wire any available connection cable of the Motor PTC/ Klixxon to terminals T1
and T2 (1) (torque: 0.6 Nm [0.44 ft lbs]).
when installing, make sure that the connection cables are not pinched.
If the motor is equipped with a temperature sensor, it is connected to ter-
minals T1 and T2 (1) and the jumper (2) included in the delivery must be re-
moved. If the jumper is used, there is no temperature monitoring of the mo-
tor!
10. Plug the drive controller to the adapter plate and secure it evenly using the
four screws at the side (torque: 4.0 Nm [0.3 ft lbs]).