Elmo Rietschle 2FC4...-1CB - Manual (Page 43)

Parameters 7
© Gardner Denver Deutschland GmbH 43 / 74 05.2014 · 610.00260.40.000
1,132 Non-tarnish protection Unit: integer
Relationship to
parameter:
1,131 Parameter HB:
S. xy
Transfer
status:
2
min: 0 Intrinsic value
(to be en-
tered!)
max: 6
Def: 0
Selection of characteristics on the control release (parameter
1,131).
No effect if autostart was selected.
0 = immediate start at a high signal at the start input of control
release
1 = start only with increasing slope at the start input of control
release
2 = digital input 1 (function active at high signal)
3 = digital input 2 (function active at high signal)
4 = digital input 3 (function active at high signal)
5 = digital input 4 (function active at high signal)
6 = integrated soft PLC
1,150 Direction of rotation Unit: integer
Relationship to
parameter:
1,131
4,030
4,050 Parameter HB:
S. xy
Transfer
status:
2
min: 0 Intrinsic value
(to be en-
tered!)
max: 12
Def: 1
Selection of the specified direction of rotation.
0 = setpoint-dependent (depending on the prefix of the setpoint:
reverse)
1 = forward only (change in the direction of rotation not possi-
ble)
2 = reverse only (change in the direction of rotation not possible)
3 = digital input 1 (0V = forward, 24V = reverse)
4 = digital input 2 (0V = forward, 24V = reverse)
5 = digital input 3 (0V = forward, 24V = reverse)
6 = digital input 4 (0V = forward, 24V = reverse)
7 = integrated soft PLC
8 = analogue input 1 (must be selected in the parameter 4,030)
9 = analogue input 2 (must be selected in parameter 4,050)
10 = membrane keyboard with button for reversal of the direc-
tion of rotation (only with running motor)
11 = membrane keyboard with button 1 for forward / 2 for re-
verse (reverse is always possible)
12 = membrane keyboard with button 1 for forward / 2 for re-
verse (reverse only possible when the motor is not running)