Agilent Technologies E1300B - Manual (Page 133)

DIAGnostic
The DIAGnostic subsystem allows control over the System Instrument’s internal
processor system (:BOOT, and :INTerrupt), the allocation and contents of User
RAM, and, disc volume RAM (:NRAM, and :RDISk), and allocation of the
built-in serial interface (:COMM:SER:OWNer).
Subsystem Syntax DIAGnostic
:BOOT
:COLD
[:WARM]
:COMMunicate
:SERial[0]
[:OWNer] [SYSTem| IBASic| NONE]
[:OWNer]?
:SERial[n]
:STORe
:DOWNload
:CHECked
[:MADDress] < address> ,< data>
:SADDress < address> ,< data>
[:MADDress] < address> ,< data>
:SADDress < address> ,< data>
:DRAM
:AVAIlable?
:CREate < size> < num_drivers>
:CREate? < MIN| MAX> ,< MIN| MAX| DEF>
:DRIVer
:LOAD < driver_block>
:CHECked < driver_block>
:LIST
:ALL?
:RAM?
:ROM?
:INTerrupt
:ACTivate [ON| OFF| 1| 0]
:SETup[n] [ON| OFF| 1| 0]
:SETUP[n]?
:PRIority[n] [< priority> | MIN| MAX| DEF]
:PRIority[n]? [MIN| MAX| DEF]
:RESPonse?
:NRAM
:ADDRess?
:CREate < size> | MIN| MAX
:CREate? [MAX MIN]
:PEEK? < address> ,< width>
:POKE < address> ,< width> ,< data>
:RDISk
:ADDress?
:CREate < size> | MIN| MAX
:CREate? [MIN| MAX]
:UPLoad
[:MADDress]? < address> ,< byte_count>
SADDress? < address> ,< byte_count>
DIAGnostic
System Instrument Command Reference 7-5