Agilent Technologies E1300B - Manual (Page 165)

•
Serial communication settings for the Agilent E1324A Datacomm
interface can be stored in its on-board non-volatile EEROM only after
the DIAG:COMM:SER[n]:STORe command is executed. These settings
are used at power-up and DIAG:BOOT[:WARM].
•
DIAG:BOOT:COLD will set the serial communication parameters to the
following defaults:
– BAUD 9600
– BITS 8
– PARity NONE
– SBITs 1
– DTR ON
– RTS ON
– PACE XON
Example Setting baud rate for plug-in card 2.
SYST:COMM:SER2:BAUD 9600 (must be a card number 1 also)
:COMMunicate
:SERial[n] :CONTrol
:DTR
SYSTem:COMMunicate:SERial[ n] :CONTrol:DTR < dtr_cntrl> controls the
behavior of the Data Terminal Ready output line. DTR can be set to a static
state (ON | OFF), can operate as a modem control line (STANDard), or can be
used as a hardware handshake line (IBFull).
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
dtr_cntrl discrete ON| OFF| STANDard| IBFull none
Comments
•
The following table defines each value of dtr_cntrl:
Value Definition
ON DTR line is asserted
OFF DTR Line is unasserted
STANdard DTR will be asserted when the serial interface is
ready to send output data. Data will be sent if the
connected device asserts DSR and CTS.
IBFull While the input buffer is not yet at the :STOP
threshold, DTR is asserted. When the input buffer
reaches the :STOP threshold, DTR will be
unasserted.
•
DIAG:BOOT:COLD will set
…
DTR to ON.
•
Related Commands: SYST:COMM:SER[n]:CONT:RTS,
SYST:COMM:SER[n]:PACE:THR:STARt,
SYST:COMM:SER[n]:PACE:THR:STOP
•
*RST Condition: No change
Example Asserting the DTR line.
SYST:COMM:SER0:CONT:DTR ON
SYSTem :COMMunicate :SERial[n] :CONTrol :DTR
System Instrument Command Reference 7-37