Agilent Technologies E1300B - Manual (Page 152)

:NRAM:CREate? DIAGnostic:NRAM:CREate? [ MIN | MAX] Returns the current or allowable
(MIN | MAX) size of the User non-volatile RAM segment.
Comments
•
DIAG:NRAM:CRE does not allocate driver RAM until a subsequent
re-boot. To get accurate results, execute DIAG:NRAM:CRE? after the
re-boot.
•
Related Commands: DIAG:NRAM:ADDRess?, DIAG:NRAM:CREate
Example Check the size of the User RAM segment.
DIAG:NRAM:CREate?
enter statement statement enters size in bytes
:PEEK? DIAGnostic:PEEK? < address> ,< width> reads the data (number of bits
given by width) starting at address.
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
address numeric 0 to 16,777,215 (# HFFFFFF) none
width numeric 8| 16| 32 none
Comments
•
Address specifies a location within the range of the control processor’s
addressing capability.
•
Address may be specified in decimal, hex (# H), octal (# Q), or binary
(# B) formats.
•
Related Commands: DIAG:POKE
Example Read byte from User non-volatile RAM
DIAG:PEEK? 16252928,8 ask for byte
enter statement return value of byte
DIAGnostic:NRAM:CREate?
7-24 System Instrument Command Reference