Agilent Technologies E1300B - Manual (Page 191)

:SELect VXI:SELect < logical_addr> specifies the logical address which is to be used by
many subsequent commands in the VXI subsystem.
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
logical_addr numeric 0 through 255 none
Comments
•
The *RST default value for logical_addr is that no logical address is
selected (i.e., -1). All other commands which require a logical address to
be selected will respond with Error -221 ("settings conflict") if no logical
address is selected.
•
When a command encounters an Error -240 ("Hardware Error") the
equivalent of a *RST is executed. This will cause the selected logical
address to be set to -1.
•
Related Commands: VXI:CONF:LADD?
Example Select a logical address
VXI:SEL 64 sets the logical address to be
used by subsequent VXI
subsystem commands to 64.
:SELect? VXI:SELect? returnsthe logical address which will be used by many subsequent
commands in the VXI subsystem. If no logical address has been selected, this
query will return -1.
VXI :SELect
System Instrument Command Reference 7-63