Agilent Technologies E1300B - Manual (Page 188)

:CONFigure
:INFormation:ALL?
VXI:CONF:INF:ALL? Returns the static information about all logical
addresses. The information is returned in the order specified in the response to
VXI:CONF:LADD?. The information about multiple logical adddresses will be
semicolon separated and follow the IEEE 488.2 response message format.
Individual fields of the output are comma separated.
Comments
•
Related Commands: VXI:SEL, VXI:CONF:INF?, VXI:CONF:LADD?
:CONFigure
:LADDress? VXI:CONF:LADD? Returns a comma separated list of logical addresses of
devices in the mainframe. This is an integer between 1 and 256 inclusive. The
logical address of the device responding to the command will be the first entry in
the list.
Comments
•
Related Commands: VXI:CONF:NUMB?
:CONFigure :NUMBer? VXI:CONF:NUMB? Returns the number of devices in the system. This is an
integer between 1 and 256 inclusive.
Comments
•
Related Commands: VXI:CONF:LADD?
:READ? VXI:READ? < logical_addr> ,< register_addr> allows access to the entire 64
byte A16 register address space for the device specified by logical_addr. Since
the VXIbus system is byte-addressed, while the registers are 16 bits wide,
registers are specified by even addresses only. This method of identifying
registers follows the VXIbus standard format.
Parameters Parameter
Name
Parameter
Type
Range of
Values
Default
Units
logical_addr decimal
numeric
must round to 0 through 255 none
register_addr numeric must round to an even value
from 0 through 62 (3E
16
)
none
Comments
•
Specifying an odd register address will cause an error 2003,"Invalid word
address".
•
Specifying a logical address not currently in the system will cause an error
2005,"No card at logical address".
•
Logical_addr must be specified in decimal. Register_addr may be
specified in decimal, hex (# H), octal (# Q), or binary (# B).
•
This command has been retained for compatibility with existing
programs. For new programs you should use the VXI:REG:READ?
command.
•
Accesses are 16-bit non-privileged data accesses.
VXI:CONFigure :INFormation:ALL?
7-60 System Instrument Command Reference