Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 15)

Operator’s Manual
922131-00 Rev A 9
Basic Controls
Powering Up Your WaveAce
1. Power On the oscilloscope by pressing the power button (located on
the lower front of the 2000 models and top left on the 1000 models,
when facing the instrument).
2. The Teledyne LeCroy Splash screen is shown. Press any key to continue
(or, after a brief period the grid display is shown).
3. The Grid Display is shown.
NOTE: The screen size varies slightly between all WaveAce Series
Oscilloscopes. Therefore, the screen-shots in this documentation may look
more narrow or wide than they appear on your specific model. However, the
screens are all functionally the same and the slight differences have no affect
when following these instructions.