Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 32)

WaveAce 1000/2000
26 922131-00 Rev A
Setting Probe Attenuation
Probes are available with various attenuation factors affecting the vertical
scale of the signal. Push the Channel button, and then the Probe menu option
button. Attenuation options for 1X, 10X, 50X, 100X, 500X, and 1000X.
NOTE:

The default setting for the Probe option is 1X.

Be sure that the Attenuation switch on the probe matches the Probe
option in the oscilloscope. Switch settings are 1X and 10X.

When the Attenuation switch is set to 1X, the probe limits the
bandwidth of the oscilloscope to 10MHz. To use the full bandwidth of
the oscilloscope, be sure to set the switch to 10X.
Inverting Waveforms
Use the following steps to invert your waveform.
1. Invert the waveform by turning on the specific channel. Press the
desired channel button - CH1 or CH2 (or CH3 or 4 on 4 channel models).
2. Now, on the channel menu, press the Next Page option button,
showing page 2/3.