Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 26)

WaveAce 1000/2000
20 922131-00 Rev A
1. Trigger Status - The following states are shown as highlighted text on
this part of the screen.

Armed - The oscilloscope is acquiring pre-trigger data. All triggers
are ignored in this state.

Ready - The oscilloscope is ready to trigger.

Trig'd - The oscilloscope has found a trigger and is acquiring the
post-trigger data.

Stop - The oscilloscope has stopped acquiring waveform data.
Shown in red highlight.

Acq. Complete - The oscilloscope has completed a Single
Sequence acquisition.

Auto - The oscilloscope is in Auto Mode and is acquiring
waveforms in the absence of triggers.

Scan - The oscilloscope is acquiring and displaying waveform data
continuously in Scan Mode.
2. USB Memory Device - Indicates whether the USB Memory Device is
inserted in the USB Port.

When a USB Memory Device is not inserted in the USB Port the
area is blank.

USB Memory Device is inserted in the USB Port (as shown
previous).

When plugging in or removing a USB Memory Device, a message
is briefly shown on the grid display as USB Flash Drive Plug In!
and USB Flash Drive Pull Out!, respectively.
3. Waveform Preview Display - This small portion at the top of the screen
shows how much of the captured waveform is currently appearing on
the display.
NOTE: Show the full waveform by stopping the trigger and turning the
Time/Div button to the left (increasing the amount of time shown on
the display).
4. Print Key - Indicates whether the Print Key option is set to Print Picture
or Save Picture.

Print Key option set to Save Picture (as shown previous).

Print Key option set to Print Picture