Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 92)

WaveAce 1000/2000
86 922131-00 Rev A
Record Menu (with Mode Set to Record)
Press the Mode option button and select Record. The Record menu (with
Mode set to Record) is shown and contains the following option button
controls (in addition to Mode).
1. Press the Source option button to choose from CH1 and CH2 (also, CH3
and CH4 on four channel versions) as the recorded signal input.
2. Press the Interval option button and use the Adjust Front Panel (on
page 7) knob to dial in the desired interval between record frames.
3. Press the End Frame option button and use the Adjust front panel knob
to dial in the desired number of record frames.
4. Press the Operate option button to Start/Stop recording.
NOTE: A record: 1 counter is shown on the upper-left part of the grid
display area which counts the number of record frames to your set End
Frame amount. After pressing the Operate option button, once the End
Frame amount is reached, a Record Wave Success notification is then
briefly shown on the lower-center part of the grid display area.