Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 81)

Operator’s Manual
922131-00 Rev A 75
P RINT S ETUP
1. Press the Print Setup... option button to set up your print options. A
separate Print screen is then shown (Page 1/2).
NOTE:

Only when the Back USB option button (covered in the next step)
is set to Printer is the Print Setup... option button enabled for
use.

After using corresponding option buttons to choose Do Self Cal,
Do Self Test, or Print Setup (when enabled by selecting Printer
on the Back USB option button), you're taken to a separate menu
based on your selection where additional options are then
shown. You can always return to the original menu from this
menu by pressing the UTILITY front panel button.

When printing, make sure your printer is connected to the back
of your WaveAce oscilloscope as covered in Back and Side
Connections (on page 8).
For more information, see Print Setup (on page 78).
B
ACK
USB
Press Back USB and choose either Computer or Printer as desired based on
what you connect to your instrument using the USB Type B Receptacle on the
back of the oscilloscope as covered in Back and Side Connections (on page 8).
Press the Next Page option button to display page 3/4.