Waveace specifications, Certifications, Emc compliance – Teledyne LeCroy WaveAce 1000_2000 User Manual
Page 98
WaveAce 1000/2000
92
922131-00 Rev A
After selecting your device connection, WaveStudio completes the setup and
the added device configuration is shown on The Scope (Device) Explorer
window.
With an established connection, the bottom half of the My Scope (Device)
Explorer window shows a tree including items like Terminal, Front Panel,
Scope Options, Traces, Display Capture, Scope Setups, Mass Storage and
LabNotebook and is where most WaveStudio features are utilized.
With your WaveAce remotely connected, the R icon is shown on the upper-
right area of the screen display and you can only change the state of the
instrument from the WaveStudio program.
Press the Force front panel button on your WaveAce to disconnect from a
WaveStudio remote control session.
NOTE: Access
for the complete WaveStudio
documentation.
WaveAce Specifications
Note: Specifications are subject to change without notice.
Please refer to the Teledyne LeCroy website at
or the
online help on your Teledyne LeCroy oscilloscope for detailed specification
information.
Certifications
This section contains the instrument’s Electromagnetic Compatibility (EMC),
Safety and Environmental certifications.
EMC Compliance
EC
D
ECLARATION
O
F
C
ONFORMITY
-
EMC
The oscilloscope meets intent of EC Directive 2004/108/EC for Electromagnetic
Compatibility. Compliance was demonstrated to the following specifications as
listed in the Official Journal of the European Communities:
EN 61326-1:2006, EN 61326-2-1:2006 EMC requirements for electrical
equipment for measurement, control, and laboratory use.
1