Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 47)

Operator’s Manual
922131-00 Rev A 41
Cursor Measurement Selections

Time cursors are vertical lines that you move horizontally to measure
the difference in time or frequency values between the cursors.

Voltage cursors appear as horizontal lines on the display and measure
the vertical parameters.

Measurement values are shown in the upper-left corner of the grid
display and are explained as follows:
Shown in Manual Cursor Mode
▲V - the vertical space between Cursor A and Cursor B (Voltage value
between the two cursors)
CurB - the horizontal position of Cursor B (in Volts)
CurA - the horizontal position of Cursor A (in Volts)
Shown in Track Cursor Mode
A→T - the horizontal position of Cursor A (Time cursor centered around
the midpoint of the screen)
A→V - the vertical position of Cursor A (Voltage cursor centered on the
channel ground level)
B→T - the horizontal position of Cursor B (Time cursor centered on the
midpoint of the screen)
B→V - the vertical position of Cursor B (Voltage cursor centered around
the channel ground level)
▲T - Horizontal space between Cursor A and Cursor B (Time value
between the two cursors)
1/▲T - the reciprocal of the horizontal space between Cursor A and
Cursor B
▲V - the vertical space between Cursor A and Cursor B (Voltage value
between the two cursors)