Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 87)

Operator’s Manual
922131-00 Rev A 81
The system software update .ads file is then loaded through the USB memory
port on the front of the oscilloscope.
1. Insert the USB memory device containing the software update in the
USB port on the front of the oscilloscope.
2. Press the front panel Utility button.
3. Press the Next Page menu option button to navigate to menu page 3/4.
Select the Update Firmware menu option button. The Update Firmware
screen is shown.
NOTE: Verify the firmware product type matches your instrument, and
that the firmware update file is stored in the root directory of the USB
memory device.

Press the SINGLE front panel button to begin loading the .ads firmware
update file from your USB memory device Using the SAVE ALL Screen
(on page 66). Otherwise, press the RUN/STOP front panel button to exit
the Update Firmware screen.

Locate the .ads firmware update file, select it, and then press the Load
option button. The following status screen is shown.

The oscilloscope then beeps aloud twice and shows a screen stating -
The firmware has been updated completely, please boot up the DSO
again. At this point, turn your oscilloscope power Off, wait a short
while, and then power it On again.
When the oscilloscope has rebooted, your update is complete.