Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 101)

Fabric OS Encryption Administrator’s Guide (KMIP) 83
53-1002747-02
Adding target disk LUNs for encryption
2
• Encryption Mode
• Encrypt Existing Data
• Key ID
• Remove button: Remove s a selected entry from the table.
3. Click Add to launch the Add New Path wizard.
The Select Target Port dialog box displays ( Figure 74 ).
FIGURE 74 Select Target Port dialog box
The dialog box is used to select a target port when configuring multiple I/O paths to a disk LUN.
The dialog box contains the following information:
• Storage Array : The Storage Array selected from the LUN view prior to launching the Add
New Path wizard.
• Host: The host selected from the LUN view prior to launching the Add New Path wizard.
• Target Port table: Lists target ports using the following identifiers:
• Target Port
• Target Port Name
• Fabric
• Container Name
4. Select the target port from the Target Port table, then click Next.
The Select Initiator Port dialog box displays ( Figure 75 ).