Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 239)

Fabric OS Encryption Administrator’s Guide (KMIP) 221
53-1002747-02
Deployment in Fibre Channel routed fabrics
4
The following is a summary of steps for creating and enabling the frame redirection zoning features
in the FCR configuration (backbone to edge).
• The encryption device creates the frame redirection zone automatically consisting of host,
target, virtual target, and virtual initiator in the backbone fabric when the target and host are
configured on the encryption device.
• Create the frame redirection zone consisting of host, target, virtual target, and virtual initiator
in both the host and target edge fabrics. The CLI command is zone
--
rdcreate [host wwn]
[target wwn] [VI wwn] [VT wwn][nonrestartable] [FCR]. Always specify nonrestartable as a
policy for creating redirection zones. The VI and VT port WWNs can be obtained by running the
cryptocfg
--
show
-
container <crypto container name>
-
cfg command on the encryption
switch or blade. After the redirection zones are created, commit the configuration with the
cfgsave command.
• Create the LSAN zone consisting of host, target, virtual target, and virtual initiator in both the
backbone fabric and the target edge fabrics. Refer to the Fabric OS Administrator’s Guide for
information about LSANs, LSAN zoning, and Fibre Channel routing (FCR) configurations.