Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 97)

Fabric OS Encryption Administrator’s Guide (KMIP) 79
53-1002747-02
Configuring encryption storage targets
2
13. Review any post-configuration instructions or messages, which you can copy to a clipboard or
print for later, then click Next.
The Next Steps screen displays ( Figure 70 ). Post-configuration instructions for installing public
key certificates for the encryption switch are displayed. These instructions are specific to the
key vault type.
FIGURE 70 Next Steps screen
The screen contains the following information:
• Important Instructions: Instructions about post-configuration tasks you must complete
after you close the wizard. For example, you must zone the physical hosts and the target
together and then you encrypt the LUNs using the Storage Device LUNs dialog box.
• Copy to Clipboard button: Saves a copy of the instructions.
• Print button: Prints the configuration.
14. Review the post-configuration instructions, which you can copy to a clipboard or print for later,
then click Finish to exit the Configure Switch Encryption wizard.