Multi-path lun configuration example – Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User Manual
Page 210
192
Fabric OS Encryption Administrator’s Guide (KMIP)
53-1002747-02
Configuring a multi-path Crypto LUN
3
Multi-path LUN configuration example
Figure 119
on page 188 shows a single LUN on a dual-port target that is accessed over two paths
by a dual-port host. The two encryption switches form an encryption group and an HA cluster. The
following example illustrates a simplified version of a multi-path LUN configuration.
FIGURE 119
A LUN accessible through multiple paths
The following steps may be used to configure multiple path access to the LUN in
Figure 119
.
1. Create zoning between host port 1 and target port 1. Refer to the section
on page 174 for instructions.
2. Create zoning between host port 2 and target port 2. Refer to the section
on page 174 for instructions.
3. On the group leader encryption switch (switch 1), create a CryptoTarget container for each
target port and add the hosts in sequence. Do NOT commit the configuration until you have
created all CryptoTarget containers and added all hosts to the respective containers.
a. Log in as Admin or FabricAdmin.
b. Create a CryptoTarget container (CTC1) for target port 1 to be hosted on the encryption
engine of encryption switch 1. Refer to the section
“Creating a CryptoTarget container”
page 178 for instructions on steps b. through e.
FabricAdmin:switch> cryptocfg --create -container disk CTC1 \
<switch 1 WWN> 0 <Target Port 1 WWN> <Target NWWN>