Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 135)

Fabric OS Encryption Administrator’s Guide (KMIP) 117
53-1002747-02
Rekeying all disk LUNs manually
2
.
FIGURE 99 Pending manual rekey operations
Viewing disk LUN rekeying details
You can view details related to the rekeying of a selected target disk LUN from the LUN Re-keying
Details dialog box.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 6 on page 14).
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Targets, or right-click the group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays.
3. Select a Target storage device, then select Group/Switch/Engine > Disk LUNs.
The Encryption Target Disk LUNs dialog box displays ( Figure 100 ). Initially the list is empty. You
must add LUNs manually.