Failover/failback policy configuration – Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) User Manual
Page 185
Fabric OS Encryption Administrator’s Guide (KMIP)
167
53-1002747-02
High availability clusters
3
Number of HA Clusters: 1
HA cluster name: dthac - 2 EE entries
Status: Committed
HAC State: Converged
WWN Slot Number Status
10:00:00:05:1e:39:a6:7e 4 Online
10:00:00:05:1e:c1:06:63 0 Online
sw153114:FID128:admin> cryptocfg --replace -haclustermember dthac
10:00:00:05:1e:39:a6:7e 4 10:00:00:05:1e:39:a6:7e 12
Slot Local/
EE Node WWN Number Remote
10:00:00:05:1e:39:a6:7e 12 Local
Operation succeeded.
After:
sw153114:FID128:admin> cryptocfg --show -hacluster -all
Encryption Group Name: disk_tape
Number of HA Clusters: 1
HA cluster name: dthac - 2 EE entries
Status: Defined
HAC State: Converged
WWN Slot Number Status
10:00:00:05:1e:39:a6:7e 12 Online
10:00:00:05:1e:c1:06:63 0 Online
sw153114:FID128:admin>
NOTE
The two engines being swapped must be in the same fabric.
Failover/failback policy configuration
Failover/failback policy parameters as outlined in
can be set for the entire encryption group
on the group leader.
Use the cryptocfg
--
set command with the appropriate parameter to set the values for the policy.
Policies are automatically propagated to all member nodes in the encryption group.