Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 59)

Fabric OS Encryption Administrator’s Guide (KMIP) 41
53-1002747-02
Steps for connecting to a KMIP appliance (SafeNet KeySecure)
2
Registering the KeySecure Brocade group user name and password
The Brocade group user name and password you created when configuring a Brocade group on the
KeySecure appliance must also be registered on each encryption node.
NOTE
This operation can be performed during or after the creation of the encryption group. During the
creation of an encryption group, the key vault step will prompt for a user name and password.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 6 on page 14).
2. Select the group leader switch from the Encryption Center Devices table, then select Switch >
Key Vault Credentials from the menu task bar.
The Key Vault Credentials dialog box displays ( Figure 30 ).
FIGURE 30 Key Vault Credentials dialog box
The dialog box contains the following information:
• Primary Key Vault: Primary Key Vault is preselected. KMIP key vaults are clustered, so only
one set of credentials is needed.
• Secondary Key Vault: (TEKA key vault only). Shown as inactive.
• User Name: Enter a user name for the group leader.
• User Group Name: Displays the selected User Group Name.
• Password: Enter a password for the group leader.
• Re-type Password: Re-enter the password for verification.
3. Enter the Brocade user name and password, then re-enter the password for verification.
4. Click OK.