Brocade Fabric OS Encryption Administrator’s Guide Supporting Key Management Interoperability Protocol (KMIP) Key-Compliant Environments (Supporting Fabric OS v7.1.0) - Manual (Page 96)

78 Fabric OS Encryption Administrator’s Guide (KMIP)
53-1002747-02
Configuring encryption storage targets
2
The screen contains the following information:
• Encryption Engine: The slot location of the encryption engine.
• Container Name: The logical encryption name used to map storage targets and hosts to
virtual targets and virtual initiators.
• Target Device Port: The world wide name of the target device port.
• Host Node WWN: The world wide name of the host node.
• Host Port WWN: The world wide name of the host port.
• Host Name: The name of the host.
12. Verify the information is correct, then click Next, which creates the configuration.
The Configuration Status screen displays ( Figure 69 ), which shows the status of the new
container configuration. The target and host that are configured in the target container are
listed, as well as the virtual targets (VT) and virtual initiators (VI).
NOTE
If you can view the VI/VT Port WWNs and VI/VT Node WWNs, the container has been successfully
added to the switch.
FIGURE 69 Configuration Status screen
The screen contains the following information:
• Device: The device type (target or host).
• Device Port WWN: The port world wide name.
• Represented by VI/VT: The virtual target (VT) mapped to the physical target or virtual
initiator (VI) representing the host.
• VI/VT Port WWN: The port world wide name of the virtual target or virtual initiator.
• VI/VT Node WWN: The node world wide name of the virtual target or virtual initiator.