HP StorageWorks XP Remote Web Console Software - Manual (Page 74)

74 Continuous Access XP Journal
NOTE: If the pair is suspended or deleted during COPY status, the primary data volume’s access attribute
is not copied to the secondary data volume. To copy the primary data volume’s access attribute to the
secondary data volume, ensure that the pair status is PAIR, and then suspend or delete the pair.
NOTE: When the primary data volume is in COPY or PAIR status, two access attributes can be changed
and cannot be changed according to the existing access attribute. For more information about the variable
access attribute, see Table 24 .
LUN Security XP Extension license capacity
To create a Continuous Access XP Journal pair using volumes with VMA, if the primary data volume has an
access attribute for which the LUN Security XP Extension license is necessary, you need the LUN Security
XP Extension license capacity for secondary data volumes in the disk array at the secondary site. This is
because when copying the access attributes is complete, primary and secondary data volumes have the
same access attributes. For more information about copying access attribute, see Figure 36 .
NOTE: If the LUN Security XP Extension license capacity is insufficient in the disk array at the secondary
site, you might not able to create Continuous Access XP Journal pairs. For more information, see the
HP StorageWorks LUN Security XP Extension User Guide.
Table 23 Pair status and availability of LUN Security XP Extension operation
Volume Pair Status LUN Security XP Extension operations
Changing access attribute
Referencing access attribute
Primary data volume SMPL OK OK
COPY 1
1. See Table 24 .
OK
PAIR 1 OK
PSUS OK OK
PSUE OK OK
Secondary data volume SMPL OK OK
COPY No OK
PAIR No OK
PSUS No 2
2. If the Write option is set to the secondary data volume, the access attribute can be changed.
OK
PSUE No OK
Table 24 Variable access attribute (pair status of Continuous Access XP Journal primary data volume is
PAIR or COPY)
Access attribute before
change
Variable access attribute
Read/Write
Read Only Protect S-VOL Disable
Read/Write — No No OK
Read Only OK — OK OK
Protect OK OK — OK
S-VOL Disable OK No No —