HP StorageWorks XP Remote Web Console Software - Manual (Page 87)

Continuous Access XP Journal user guide 87
• Last Updated: Date and time when the last operation on a logical path to the remote disk array was
performed.
• Refresh the DKC Operations tab after this panel is closed: If selected, information in the DKC Operation
pane is refreshed after you close the DKC Status pane.
• Refresh: Refreshes the information in the DKC Status pane.
• Close: Closes the DKC Status pane.
Removing the relationship between primary and secondary disk arrays
Use the DKC Operations pane to remove the relationship between the primary and secondary disk arrays
and then remove all logical paths between the two disk arrays. The primary and secondary disk array
administrators must perform the following procedure:
1. Ensure that all affected Continuous Access XP Journal volume pairs have been deleted.
2. Ensure that the Command View XP or XP Remote Web Console main pane is in Modify mode. For
more information, see the HP StorageWorks Command View XP User Guide for XP Disk Arrays or the
HP StorageWorks XP Remote Web Console User Guide for XP12000/XP10000.
3. Ensure that the DKC Operation pane is displayed.
4. In the Switch Display box, select DKC.
5. Select Subsystem from the tree. The list displays remote disk arrays.
6. Select and right-click the remote disk arrays from the list.
7. Select DKC Operations and Delete DKC. A confirmation message appears.
Table 25 Logical path status
Status Remarks
Normal This path was successfully established and can be used for Continuous Access XP Journal
remote copy activities.
Nothing An operation for configuring or deleting this logical path is in progress.
Initialization Failed An error occurred with initialization of connection between the local and remote disk
array. The probable causes are:
• No cable is connected to the local disk array.
• No cable is connected to the remote disk array.
• No cable is connected to the network device that comes between the local and
remote disk arrays.
Communication Time
Out
This status indicates one of the following:
• A timeout error occurred between the primary and secondary disk arrays.
• A logic error was detected between the primary and secondary disk arrays.
Resource Shortage
(Port)
The local disk array rejected the function for configuring logical path connection. All
logical path resources in the local disk array might be used for other connections.
Resource Shortage
(Pair-Port)
The remote disk array rejected the function for configuring logical path connection. All
logical path resources in the remote disk array might be used for other connections.
Serial Number
Mismatch
The serial number of the disk array connected to this logical path does not match the
serial number specified by the Add DKC pane.
Invalid Port The port is not an initiator port.
Pair-Port Number
Mismatch
This status indicates one of the following:
• The specified port number is incorrect.
• The port in the remote disk array is physically disconnected from the local disk array.
Pair-Port Type Mismatch The port on the remote disk array is not an RCU target port.
Communication Failed A communication timeout error has occurred on the path between the primary and the
secondary disk arrays.