HP StorageWorks XP Remote Web Console Software - Manual (Page 99)

Continuous Access XP Journal user guide 99
This column is blank if the journal group’s attribute is not Master or Restore.
NOTE: The controller ID for an XP10000/XP12000 disk array is 4.
• Path Watch Time (min): Time for monitoring blockade of paths to the remote disk array.
• Previous: Displays detailed information about the previous journal group.
• Next: Displays detailed information about the next journal group.
• Close: Closes the JNL Group Detail pane.
Changing options for journal groups
If you are logged onto an XP10000, you can perform this operation only on journal groups that have a
number below 10.
Both primary and secondary disk array administrators must perform this operation.
1. Ensure that the Command View XP or XP Remote Web Console main pane is in Modify mode. For
more information, see the HP StorageWorks Command View XP User Guide for XP Disk Arrays or the
HP StorageWorks XP Remote Web Console User Guide for XP12000/XP10000.
2. Ensure that the Journal Operation pane is displayed (see ” Displaying the Journal Operation pane ” on
page 88).
3. Do one of the following:
• In the tree, right-click a journal group from below Registered, and select JNL Groups and Change
JNL Option.
• In the upper-right list, right-click the desired journal group, and select JNL Groups and Change JNL
Option.
CAUTION: You can select Change JNL Option only when one of the following conditions is
satisfied:
• The journal group’s attribute is Initial.
• The journal group’s status is Stop.
• The journal group’s status is Active.
4. In the Change JNL Option pane, change journal group options, and click Set.
CAUTION: If the journal group’s status is Active, you can change only the Line of Speed option.
NOTE: If you selected two or more journal groups in step 3 and want to leave some options in the
Change JNL Options pane unchanged, specify blank for the options. If you specify blank for an
option, the option value remains unchanged. If you specify a value other than blank, the specified
value is set to the selected journal groups.
5. In the Preset list, check the settings you made.
• To modify a setting, select and right-click the setting in the Preset list, and select Modify.
• To cancel a setting, select and right-click the setting, and select Cancel.
6. Click Apply to apply the settings.