HP HSG Array Controller - Manual (Page 172)

B-32 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
ipAddrSet
Figure B-16 shows the ipAddrSet command which is used to set the Switch’s
Ethernet IP Address, Ethernet Subnetmask, Fibre Channel IP Address, Fibre
Channel Subnetmask, and Gateway Address. The fields are described in
Table B-8.
admin> ipAddrSet
Ethernet IP Address [192.158.1.14]:
Ethernet Subnetmask [255.255.255.0]:
Fibre Channel IP Address [none]:
Fibre Channel Subnetmask [none]:
Gateway Address [192.158.1.1]:
value = 0 = 0x0
Figure B-16. ipAddrSet Command Example
Table B-8
ipAddrSet Command Descriptions
Field Description
Ethernet IP Address The default IP address on a new Switch is a
temporary number derived from the Switch’s
WWN. Enter a valid IP address.
Ethernet Subnetmask The Ethernet subnetmask value. The default
subnet mask value is none. Refer to the network
administrator for the appropriate subnet mask
value to enter here.
Fibre Channel IP Address The Fibre Channel IP address for the Switch. Enter
a valid IP address.
Fibre Channel Subnetmask The Fibre Channel subnetmask for the Switch.The
default is none. The default subnetmask value is
none.
Gateway IP Address The gateway IP address. The default gateway
address on a new Switch is none. You must enter a
valid gateway address, if required.
NOTE: Consult your network administrator for the appropriate subnetmask.