HP HSG Array Controller - Manual (Page 193)

Telnet Commands B-53
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
reboot
Figure B-31 shows the reboot command which reboots the Switch to the
stored configuration in flash memory and takes about 1 1/2 minutes. The
Switch maybe in any operational state (enabled or disabled) before rebooting.
admin> reboot
Figure B-31. reboot Command Example
syslogdIp
Figure B-32 show the syslogdIp command which sets or displays the
Switches system log daemon IP address.
The command syntax is syslogdIp <“ip address”>.
admin> syslogdIp
syslog daemon’s address: 0.0.0.0
value = 35 = 0x23 = ’#’
Figure B-32. syslogdIp Command Example
switchDisable
Figure B-33 shows the switchDisable command used for diagnostic tests,
similar maintenance functions, or replacing a faulty Switch.
You can observe and verify this process by watching the front panel LEDs
change color from green to slow flashing amber as each port goes inactive.
admin> switchDisable
value = 0 = 0x0
Figure B-33. switchDisable Command Example