Switchenable – HP HSG Array Controller User Manual
Page 194
B-54 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: i-appb Telnet Commands Last Saved On: 4/7/99 12:36 PM
switchEnable
The
switchEnable
command enables the Switch and provides Fabric
information. The Switch may need to be enabled after maintenance and
diagnostic tests.
In Figure B-34, the Switch is enabled with a domain ID of 1. After the Fabric
is reconfigured this Switch is the principle address manager that is capable of
assigning domain IDs to other Switches in the same Fabric.
You can observe and verify this process by watching the front panel LEDs
change color from green to slow flashing amber as each port goes inactive.
admin> switchEnable
value = 0 = 0x0
10 9 8 7 6 5 4 3 2 1
fabric: Principal switch
fabric: Domain 1
Figure B-34. switchEnable Command Example
NOTE: When a Switch is powered on, it is automatically enabled.