HP HSG Array Controller - Manual (Page 68)

3-34 StorageWorks Fibre Channel Storage Switch User's Guide
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments:
Part Number: AA-RHBYA-TE 135267-001 File Name: d-ch3 Managing the Switch Last Saved On: 4/7/99 11:59 AM
■ swFCPortScn - a notification that a Fibre Channel Port changes its
operational state. For instance, the Fibre Channel Port goes from on-line
to offline. The VarBind in the Trap Data Unit contains the
corresponding instance of the port's operational status.
NOTE: SNMP swFCPortScn traps are generated on GBIC insertion and removal even
though the state remains offline.
Agent Configuration
NOTE: Changes to SNMP from either Telnet or SNMP are not displayed in SNMP until the
Switch is rebooted running. This is due to SNMP running from cache while the active
settings are running from the flash PROM.
The parameters that can be configured include:
■ SNMPv1 communities (up to 6)
■ trap recipients (1 per community)
■ sysName
■ sysContact
■ sysLocation
■ authenticationFailure – indicates the agent has received a protocol
message that is not properly authenticated. This trap, by default, is
disabled but can be enabled via the command
agtcfgSet .
The sysX parameters can be configured via the SNMPv1 SET command with
an appropriate community. These parameters can be configured via a Telnet
connection, using the command
agtcfgSet .
NOTE: A change in the first two configuration parameters takes effect only after rebooting
the Switch.