American Fibertek SM8P-SFP - Manual (Page 237)

225 Rev.A1
18-May-11
restore user
Syntax:
restore user
Description:
To restore the startup configuration as user defined configuration. If restoring default
successfully, the CLI would prompt if reboot immediately or not. If you press Y or y,
the system would reboot immediately; others would back to the CLI system. After
restoring user-defined configuration, all the changes in the startup configuration
would be lost. After rebooting, the entire startup configuration would replace as user
defined one.
Argument:
None.
Possible value:
None.
Example:
SM8P-SFP# restore user Restoring
...
Restore User Configuration Successfully Press
any key to reboot system.
save start
Syntax:
save start
Description:
To save the current configuration as the start one. When you enter this command,
the CLI would save your current configuration into the non-volatile FLASH. If you
want the configuration still works after rebooting, save the configuration using the
command ‘save stat’.
Argument:
None.
Possible value:
None.
Example:
SM8P-SFP# save start
Saving start...
Save Successfully
SM8P-SFP#