American Fibertek SM8P-SFP User Manual
Page 70
Rev.A1
18-May-11
62
Member Port:
This is used to enable or disable if a port is a member of the new added
VLAN, “Enable” means it is a member of the VLAN. Just tick the check
box (
)
beside the port x to enable it.
Add new VLAN:
Please click on <Add new VLAN> to create a new Tag-based VLAN.
Input the VLAN name as well as VID, configure the SYM-VLAN function
and choose the member by ticking the check box beside the port No.,
then, press the <Apply> button to have the setting taken effect.
Delete Group:
Fig. 3-19
Just press the <Delete> button to remove the selected group entry from
the Tag-based group table.
Fig. 3-20
Note: If you need use PVLAN( Private VLAN) function on Switch then you
need follow up the process as below:
a.
Create a VLAN as primary VLAN and the VLAN ID is 2 and evoke the Private
VLAN to enable Private VLAN service.
b.
Assign port member to the VLAN2