Avaya AP-6 - Manual (Page 165)

Management
Avaya Wireless AP-4/5/6 User’s Guide 4-67
IP Access Table
The Management IP Access table limits in-band management access to
the IP addresses or range of IP addresses specified in the table. This
feature applies to all management options (SNMP, HTTP, and CLI)
except for CLI management over the serial port. To configure this table,
click Add and set the following parameters:
• IP Address: Enter the IP Address for the management station.
• IP Mask: Enter a mask that will act as a filter to limit access to a
range of IP Addresses based on the IP Address you already
entered.
— The IP mask 255.255.255.255 would authorize the single
station defined by the IP Address to configure the
Access Point. The AP would ignore commands from any other
IP address. In contrast, the IP mask 255.255.255.0 would
allow any device that shares the first three octets of the IP
address to configure the AP. For example, if you enter an IP
address of 10.20.30.1 with a 255.255.255.0 subnet mask, any
IP address between 10.20.30.1 and 10.20.30.254 will have
access to the AP’s management interfaces.
• Comment: Enter an optional comment, such as the station name.
To edit or delete an entry, click Edit. Edit the information, or select
Enable, Disable, or Delete from the Status pull-down menu.