Avaya AP-6 - Manual (Page 249)

Configure Multiple SSID/VLAN/Security Mode Entries
Avaya Wireless AP-4/5/6 User’s Guide 4-151
RAD Configuration Requirements
The RAD feature can be configured/monitored via the HTTP, CLI, or
SNMP management interfaces.
The following management options are provided:
• The RAD feature can be enabled or disabled.
• The repetition interval of RAD can be configured.
• SNMP Traps are sent after completion of a RAD scan cycle and also
whenever a new Access Point is detected.
• Additionally, the RAD scan results are maintained in a table that can
be queried via SNMP. The system administrator has to enable RAD
on the Access Points in the wireless network and also configure the
Trap Host on all these Access Points to the IP address of the
management station. The Access Points on detecting a new Access
Point sends a RAD Scan Result Trap to the management station.