Avaya AP-6 - Manual (Page 338)

Recovery Procedures
7-22 Avaya Wireless AP-4/5/6 User’s Guide
4. Open your terminal emulation program (like HyperTerminal) and
set the following connection properties:
— Com Port: <COM1, COM2, etc., depending on your computer>
— Baud rate: 9600
— Data Bits: 8
— Stop bits: 1
— Flow Control: None
— Parity: None
5. Under File -> Properties -> Settings -> ASCII Setup, enable the
Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line
of code.
6. Press the RESET button on the AP.
Result: The terminal display shows Power On Self Tests (POST)
activity. After approximately 30 seconds, a message indicates:
Sending Traps to SNMP manager periodically. After this
message appears, press the ENTER key repeatedly until the
following prompt appears:
[Device-Name]>