Avaya AP-6 - Manual (Page 175)

Management
Avaya Wireless AP-4/5/6 User’s Guide 4-77
configured for static IP, these parameters are instead configured in the
AP interface.
After setting up automatic configuration you must reboot the AP. When
the AP reboots it receives the new configuration information and must
reboot one additional time. If Syslog is configured, a Syslog message will
appear indicating the success or failure of the Automatic Configuration.
Set up Automatic Configuration for Static IP
Perform the following procedure to enable and set up Automatic
Configuration when you have a static IP address for the TFTP server.
1. Click Configure > Management > AutoConfig. The Automatic
Configuration Screen appears.
2. Check Enable Auto Configuration.
3. Enter the Configuration Filename.
4. Enter the IP address of the TFTP server in the TFTP Server
Address field.
NOTE:
The default filename is config. The default TFTP IP address is
“169.254.128.133” for the AP.
5. Click OK to save the changes.