Avaya AP-6 User Manual
Page 251
Configure Multiple SSID/VLAN/Security Mode Entries
Avaya Wireless AP-4/5/6 User’s Guide 4-153
Configuring RAD
Perform this procedure to enable RAD and define the Scan Interval.
The RAD screen also displays the time of the last scan and the number of
new access points detected in the last scan.
1. Enable the Security Alarm Group. Select the Security Alarm Group
link from the RAD screen. Configure a Trap Host to receive the list
of access points detected during the scan.
2. Click Configure > Security > RAD.
3. Enable RAD by checking Enable Rogue AP Detection.
4. Enter the Scan Interval.
The Scan Interval specifies the time period in minutes between
scans and can be set to any value between 15 and 1440 minutes.
5. Click OK.
The results of the RAD scan be viewed in the Status page in the HTTP
interface.