Avaya AP-6 - Manual (Page 43)

Hardware Installation
Avaya Wireless AP-4/5/6 User’s Guide 2-13
7. Connect one end of an Ethernet cable to the Access Point’s
Ethernet port. The other end of the cable should not be connected
to another device until after the installation is complete.
— Use a straight-through Ethernet cable if you intend to connect
the Access Point to a hub, switch, patch panel, or Power over
Ethernet power injector.
— Use a cross-over Ethernet cable if you intend to connect the
Access Point to a single computer.
8. If you are not using Power over Ethernet (or you want to connect
the Access Point to Power over Ethernet and AC power
simultaneously), attach the AC power cable to the Access Point’s
power port.